What should be paid attention to when placing materials in the lignite dryer

When using a lignite dryer to dry lignite, it is necessary to operate according to the specified requirements, otherwise it may cause irreparable losses, especially when placing materials such as lignite, extra caution should be exercised.

For users who are using a lignite dryer for the first time, the rules for material placement may not be clear. Below, professional technicians from Shenyang Yuanda will introduce the precautions for operation.

Lignite dryer 

The following precautions should be taken when placing materials on a lignite dryer:

1. When cutting, attention should be paid to blocking the feeding port. Lignite contains a large amount of water and is easy to bond together. If it sticks together during cutting, it will cause the material to block the warehouse opening in blocks, which will prevent the lignite from falling down and entering the dryer, making it impossible to carry out drying operations. In addition, in addition to being careful when cutting materials, our engineers have also made corresponding adjustments to this dryer. A mixing device is installed at the cutting port, which can effectively prevent materials from sticking together and blocking the warehouse opening.

2. When cutting materials, attention should be paid to the quantity requirements. The quantity requirements are mainly determined based on the output of the lignite dryer. If the output is insufficient, giving too much material is not conducive to the operation of the dryer.

3. Humidity control during feeding. The humidity of different lignite varies, with some being high and some being low. When drying lignite, it is necessary to check the humidity of the lignite and choose the appropriate feeding standard based on the different humidity of the material.

When drying different materials, the methods used are also different. Shenyang Yuanda reminds users to always pay attention to the above three points when using a lignite dryer to place materials. Only in this way can accidents be reduced in the drying process and production efficiency be better improved.